The Makinex Generator Range is a top - notch solution for powering various equipment and tools. It's perfect for rental yards, construction sites, and rural areas. This generator is compact and lightweight, making it easy to move around building sites and on and off vehicles. It can be used for floor grinding, welders, brick saws, air compressors, and a wide range of applications. Reasons to invest in this generator include: an alternator that provides up to 15% more power from the engine, fully Australian design, a 3 - year warranty, comprehensive support including servicing, spare parts, and on - hand advice, a full range of accessories like a Long Range Fuel Tank and Parallel Box, and permanent magnet alternator technology that cuts down the cost of ownership. On the job, you might face challenges like getting power close to your work area, combining 3 - phase and single - phase outlets, and having a light and compact generator for easy vehicle loading and unloading. Our generator solves these issues with its status as the most compact on the market, 15% more power from the same engines, paralleling capacity, a Honda engine, and both 3 - phase and single - phase outlets. Here are the product details: Rated output is 8500W, Max output is 9000W, Frequency is 60Hz, Voltage is 120V/240V + 240 3 - phase, Sockets include 30 Amp 3 - phase / 30 Amp single - phase 20Amp, Weight is 220Ib (100kg), Noise Level (7) is 72dB at no load, 76dB at 50% load, and 78dB at 100% load, Engine is Honda GX - 390, Starting System is Recoil start, Engine Fuel Economy is 0.6gal @ 50% load, Run Time is 2.6hrs, and Dimensions are 23.5in[L] x 24in[W] x 45.75in[H].
Using this generator is easy. First, make sure it's on a flat and stable surface. Check the fuel level and fill it up if needed. For starting, use the recoil start as described in the manual. Connect your equipment to the appropriate sockets, whether it's single - phase or 3 - phase. When using it, keep in mind that it can get noisy, especially at full load. So, if you're in a noise - sensitive area, be aware of that. Also, make sure there's good ventilation around the generator to avoid carbon monoxide build - up. For maintenance, regularly check the oil level and change the oil as recommended in the manual. Keep an eye on the air filter and clean or replace it when it gets dirty. Check the spark plug and replace it if it's worn out. If you're not going to use the generator for a long time, drain the fuel to prevent it from going bad. And always keep spare parts like fuses and filters on hand. If you have any questions or run into problems, our support team is ready to help.
